Electrical Connection - Pfannenberg PA X 10-10 Serie Notice Abrégée

en

Electrical connection:

(Circuit board in lower part)
PA 1/ PA 5
External
tone selection
(see S1B for
polarity)
Operating voltage connection
Tone settings
(circuit board in the upper part)
DC version
-
Factory setting
+
S3
S1
S1
S2
with rectifier
Factory setting
without rectifier
The desired tone can be selected using the S3 tone selector switch. The tone is generated after the supply voltage is applied. A complete tone type table can be found in
the Annex. See the digital operating instructions for the external control of other tones, source:
09/2021
Common connection of flashing light and sounder
tone selection
(see S1B for polarity)
S3 Tone selector switch
S2
Quick guide PA 10/ 20
(factory setting)
Connector from flashing
light circuit board
External
Operating voltage connection
Volume control
Note:
The volume control must be in the maximum
position in order to conform to EN54-3.
PA 10: in maximum position
PA 20: in the factory-set and secured position
S1: Selection of control voltage polarity for C1
and C2 (external control)
S2: Bridging Rectifier (external control)
www.pfannenberg.com/manuals.
5/12
PA X 10-10/..-15 / PA X 20-10/ ..-15
PA X 1-05 / PA X 5-05 /..10
Separate connection of flashing light
and sounder
External
tone selection
(see S1B for
polarity)
Operating voltage connection for
sounder
S3
Tone selector switch
Connector from
flashing light circuit
board
Operating voltage connection
for flashing light
AC version
086050001a