Thermador PROFESSIONAL PRO GRAND PRG36 Manuel D'installation page 19

Installing a Backsplash with a Keep Hot Shelf
A hood can be installed first if the Backsplash is to be
installed with a Keep Hot Shelf given that the Keep Hot
Shelf covers the top mounting screws of the Backsplash
(Figure 15).
• To protect against scratches, leave protective film on
the backsplash until after installation is complete.
• If range is already installed, refer to the manufacturer's
instructions to disconnect gas and power supplies.
Move range forward to gain access to rear of unit.
F 15: B
IGURE
K H
ACKSPLASH WITH A EEP OT
1. Locate wall studs.
• Wall studs are usually installed with a 16" (406mm)
or 24" (1372mm) space on center.
2. The height of the hood will determine the height of the
top edge of the backsplash. The backsplash should be
mounted so that the bottom rear edge of the Keep Hot
Shelf overlaps the backsplash 1
3. At the locations indicated in Figure 16, mount the lower
shelf brackets included with the Keep Hot Shelf
through the Backsplash and into the wall studs.
• Due to variable wall stud widths and varying
backsplash widths, in some cases, only one wall
stud may be found at the mounting location.
4. Remove backsplash protective covering.
5. Start with the Keep Hot Shelf Installation.
S
HELF
1
" (38mm).
/
2
F 16: B
IGURE ACKSPLASH WITH A
K H S
EEP OT HELF
English 17