hestan KEC Serie Manuel page 15

CONTROLS AND SETTINGS
TIMERS
There is one timer for each cooking zone, plus an independant timer.
NOTE: Timers are simply reminders - they do not control elements or turn them off.
INDEPENDANT TIMER
1. Make sure no zone is flashing/waiting for input
2. Touch the or keys to activate the timer and set the value. The maximum value is 99.
+ −
3. To cancel the timer, either use the
to zero the timer.
To check the independent timer value when it's not displayed with the highest priority, touch [T-] or
[T+] when no zones are selected. The timer led (ref.4) flashes and the displayed value switches to the
independent timer.
ZONE TIMER
Each zone can have its own timer set.
1. Touch the ON key for the cooking zone
2. Touch the or keys to activate the timer and set the
+ −
value.
3. When the indicator goes steady, the value is accepted.
• If more than one timer is set, the display shows the
lowest value, the one that will expire first. The timer led
(ref.4) related to the zone which the displayed value is
referring to, is flashing. If the displayed value refers to the
independent timer, the timer led (ref.2) flashes.
• To check the remaining time for any one of the timed zone, touch the [ON] key related to the
zone: the corresponding timer led will begin to flash and the
value on the timer display will switch for some seconds to the
new value. After a time-out, it will switch back to the shortest
one.
WHEN THE TIMER VALUE ELAPSES:
An end of activity beep sequence sounds: three short beeps
followed by a long interval are repeated for 1 minute.
The led indicator related to the elapsed timer flashes.
The timer value "00" flashes too and will continue to flash waiting
for a user confirmation.
• Touch [T-J or [T +1 to cancel the expired timer, the display
switches to the next shortest timer or gets blank if there aren't
any other timer set.
WARNING: the timer is only intended as an acoustic advisor that recalls
the attention of the user.
Timers have no effect on the heating elements. The cooking zone must always be stopped manually
by touching the related [OFF] key.
All manuals and user guides at all-guides.com
(CONTINUED)
or keys to set the time to zero, or touch them both at once
+ −
2
1
3
Figure 10.
Figure 11.
Figure 12.
©2018 Hestan Commercial Corporation
EN
4
4
13