System Status - Velleman CTC1000 Mode D'emploi

1. Use the up and down arrows to select the option you want for the remote control.
Personal att: the control panel will give a personal attack alarm when the panic button is pressed for 3
o
seconds or twice within 3 seconds.
o Medical Emg: the control panel will give a medical emergency alarm when the panic button is pressed
for 3 seconds or twice within 3 seconds.
2. Use the up and down arrows to select a working mode and press OK.
For details about the available working modes, see section 9.3.
3. Provide a zone name.
If you do not want to use a name, leave this field blank.
For information about entering text, see section 17.
4. Press OK to confirm installation.
5. Press OK again to finish.
To add a remote keypad or water sensor
Installation is similar for all these device types.
Assuming you have assigned a zone number (see section 9.2):
1. Provide a zone name.
If you do not want to use a name, leave this field blank.
For information about entering text, see section 17.
2. Press OK.
3. Press OK again to finish.
To add an auxiliary device (Program Siren menu)
Indoor and outdoor sirens and universal receivers are considered auxiliary devices by the system. Before
adding one of these auxiliary devices, you need to add at least one other device first (detector or remote
keypad). The system displays an error message if this is not the case.
1. Enter Program mode, go to Devices+/-, select Program Siren, then Learn Siren and press OK.
2. Put the device you want to add into learning mode (see this device's user manual).
3. Press OK.
The control panel will sound a long beep and transmit learning code to all devices simultaneously. The
outdoor siren should respond by activating its siren and strobe light momentarily. The LED on the universal
receiver lights up for 3 seconds.
9.3 Add a device: overview of working modes
The overview below lists the possible modes for all devices taken together. The modes that are actually
available depend on the type of device you are adding.
Mode

System status

Burglar When the system is in Away Arm / Home
Arm, or during the Entry Delay or Exit
Delay period
Home Omit
when the system is in away arm mode
(incl. away arm entry)
when the system is in home arm mode, if
a home omit door contact is triggered
during the entry delay or exit delay
period, if a home omit door contact is
triggered
V. 04 – 11/02/2016
CTC1000
Device behaviour
if a burglar door contact is triggered, a burglar
alarm will be activated immediately
if a home omit door contact is triggered, a
burglar alarm will be activated immediately
the control panel will not respond
the control panel will not respond
21 ©Velleman nv