Add A Device - Velleman CTC1000 Mode D'emploi

Sets the beep to on or off when the control panel displays an error message.
•
The warning beep will disappear when the error message has been read.
•
GSM band
Depending on service provider's network settings, you will need to adjust the GSM band setting accordingly.
Check with our local telecom service provider for the appropriate setting.
Stop
Select Stop and press OK key to save your settings and return to the previous menu.
9. Managing devices
The menu Devices+/- allows managing (add, configure, change, remove) devices like door contacts, PIR
sensors, sirens, etc. in up to 30 zones.
Order of installation
Indoor and outdoor sirens and universal receivers are considered auxiliary devices by the system. Before
adding one of these auxiliary devices, you need to add at least one other device first (a door contact, PIR
detector or remote control).
9.2

Add a device

To access the function:
1. Enter Program mode, go to Devices+/-, select Add device and press OK.
2. Press the test button on the device you want to add.
3. If the control panel detects the device, it will show the device type:
The possible devices are:
Door Contact
•
PIR Sensor
•
• External PIR Sensor
• Remote Controller
Remote Keypad
•
Water Sensor
•
Outdoor Siren
•
Universal Receiver
•
4. Press OK to confirm.
V. 04 – 11/02/2016
CTC1000
18 ©Velleman nv