Velleman CTC1000 Mode D'emploi page 10

2. Use the arrow keys to select the code you want to delete and press OK.
3. Press OK again.
7.5 Temp. Code
Use Used to arm or disarm the alarm system for a temporary user
•
Valid only once for turning the alarm on or off.
•
Once used, the code is automatically erased and needs to be reset if necessary
•
Default value Not set
•
Properties
• 4 digits
• Optional
Will be cleared when resetting the system (see chapter System reset)
•
To set a temporary code
1. To access the menu item: enter Program mode, go to Gen. Settings, select Temp. Code and press OK.
2. Key in a 4 digit code and press OK.
3. Repeat the code and press OK.
4. Set the option Latch Rpt. (latch key reporting) to on or off.
This option is only visible if the Latch Option is set to ON in the Special Settings.
o
See section Latch Option in chapter 8 Special Settings for detailed information.
5. Press OK.
To change a temporary code
1. To access the menu item: enter Program mode, go to Gen. Settings, select Temp. code and press OK.
2. Press .
3. Refer to topic To set a temporary code above.
To delete a temporary code
1. To access the menu item: enter Program mode, go to Gen. Settings, select Temp. code and press OK.
V. 04 – 11/02/2016
CTC1000
10 ©Velleman nv