KETRON MIDI PRO Guide Pratique page 29

DJ
Press the DJ key to access a different song play mode. The 2 Players are shown as 2 turn tables. The one selected is
highlighted in red. The directory for selection of files and folders is displayed at the centre. Each Player has a pair of level
indicators and the keys described below:
- CUE: Is a marker that once it has been set at any point of a song, when it is pressed again the song starts from that
point. It is compatible with Wave files and Midi files but not with Mp3 files.
- PFL: Playback in headphones. The PFL is selected automatically taking the corresponding slider to 0.
- []>: Pause.
The functions for the player selected are displayed at the bottom:
- BACK SPIN: Ends reproduction by suddenly increasing the speed and tone.
- SYNC: Synchronises the two Players. If you are playing a Midi file on turntable A and you prepare another Midi file on
turntable B, when you press SYNC the second Midi file will start in "downbeat". If Lock Tempo is inserted, the second
Player maintains the same Bpm speed as the first one. If the second file is an audio file, the latter starts at the beginning
of the next Midi file measure. If however the first file is an audio file, the TAP window (see below) will open with a pad to
start the second song after tapping the virtual pad 4 times. If you beat 4 taps in time with the first file, the second file will
be synchronised with the first.
- TAP: Opens a pad at the centre to synchronise the tempo with the "tapping" of your fingers
- FX PAD: This works only with audio files and opens a small box with the following effects: Pitch, (frequency) Cutoff and
Filter Resonance, and finally the tempo. These effects may be regulated with the corresponding sliders on the instrument
panel.
- RESET: Restores the default conditions of the file, cancelling the modifications made on this page.
- BRAKE: Ends reproduction by decreasing speed and tone, giving an effect similar to when power supply of a record
player i suddenly cut off.
/27