Beko MWOTR30102SS Mode D'emploi page 10

7 VENTILATION SYSTEM
Step 3
• Turn the blower unit so that the fan blade open-
ings are facing back (rear of unit). See Figure 9.
CAUTION: Wires to blower unit must be routed
properly to avoid pinching wires before reinstalla-
tion of cover plate.
After : Fan blade openings facing rear
Turn the blower motor clockwise 180˚
Figure 9
• Use side cutters or tin snips to cut and remove
parts B from back plate. Be careful not to distort
the plate. See Figure 10.
Figure 10
10 / 29 EN
TINSKB303MRR0_MWOTR30102SS_Beko OTR_Install Manual.indd 10 TINSKB303MRR0_MWOTR30102SS_Beko OTR_Install Manual.indd 10
Step 4
• Place the blower unit into the opening and
secure it to the oven with the screws (3) from
step 2. See Figure 11.
• Carefully match the exhaust opening location of
the microwave and attach the damper to the rear
plate by sliding it into the guides at the rear plate.
See Figures 12, 13.
• Ensure that the damper hinge is on the top and
the damper swings freely into the wall outlet.
Parts B
Over The Range Microwave Oven / Installation Manual
Figure 11
Damper
Figure 12
Figure 13
8/19/20 2:41 PM 8/19/20 2:41 PM