Velleman Velbus VMB4IRT Guide Rapide page 5

2. For use with the VMB8IR / VMBGPOB / VMBGPOW
Activate the infrared feature in the VelbusLink software if you want to control the
VMBGPOW/VMBGPOB with the 4-channel infrared transmitter 'VMB4IRT'.
The 4-channel infrared transmitter by default operates the first page of the VMBGPOB/VMBGPOW.
If you want to control other pages, follow the procedure below:
• Press and hold 'Mode'-button of the remote
• Press and hold button '2' of the remote. The indicatorled of the remote will flash briefly every 3s.
• Watch the VMB8IR / VMBGPOB / VMBGPOW closely.
• As soon as the desired channel of the VMB8IR or button 1 of the VMBGPOB / VMBGPOW page you wish to control responds, release all buttons of
the remote.
• The 3 following channels/buttons are controlled with button 2, 3 and 4 of the remote.
• This procedure can take a couple of minutes, depending on the address setting of the VMB8IR / VMBGPOB / VMBGPOW.
• Close the remote by means of the 3 screws
• You device is ready to be used
- 5 -