Circuit Diagram - Olsberg 14/563 Notice D'utilisation

Circuit Diagram

Electric storage heater
a) For direct-line control of the heater elements, remove
the "L1" wire and replace it on terminal "SH". If the in-
stallation has separate leakage current operated cir-
cuit breakers, the "N" wires are to be switched by the
same circuit breaker.
36
All manuals and user guides at all-guides.com
3) 78/4514.5631
Factory
setting
Fitted components:
B1 Charge thermostat electric
B2 Core temperature sensor
B3 Jumper bridge „Max. Charge"
B4 Charge intensity regulator
B5 Charge thermostat
E1.1 Storage heating element above
E1.2 Storage heating element middle
E1.3 Storage heating element below
F1 Charge limiter
F3 Safety thermostat for fan
K1 Thermal relay
M1 Fan
R1 Protective resistance 22 Ohm
X1 Terminal block current feed
X2 Terminal block for control cables
Tick connected
power setting!
On site wiring
to a further
storage heater
Load-current to storage heater
3/N/PE~400V
to further
storage heaters
Control current
to
storage heater
1/N/PE~230V
e.g. 5x1.5mm²
Accessory:
B6 Room thermostat
E2 Day-acting element
F2.1 DAE control thermostat
F2.2 DAE safety cut-out
Caution!
Even if the main circuit
breakers are switched off,
some terminals carrying on-
peak current, especially
terminals A1/Z1 and A2/Z2
can still be live.
Distributor
panel
Distributor
panel
Charge control
cable
(if applicable)
Distributor
panel