Wall-Mounting; Supporting Feet (Accessories) - Olsberg 14/563 Notice D'utilisation

Wall-mounting

When wall mounting, first fix the wall-mounting brack-
ets to the wall (using 4 screws per bracket) with a
clearance of „H" and a tolerance of max. ± 10mm
(Fig.1, table 1) using the materials supplied or other,
more suitable materials (mounting holes in the brack-
ets are of 10mm diameter). The clearances to be ad-
hered to are found in the chapter „minimum clear-
ances".
The wall surface on which the brackets sit should be
even. If this is not the case, suitable underlay material
must be used.
Slip the mounting feet into the 3 slots in the brackets
as shown in Fig.2.
Table 1

Supporting feet (accessories)

The wall-mounting brackets can also be supported
separately using supporting feet. Only in this case is
the dimension from the floor to the lower edge of the
heater 102mm.
From this, the following dimensions for the various drill
holes for screwing the wall-mounting brackets to the
floor are to be measured:
1. hole: 122mm
2. hole: 207mm
3. hole: 327mm
4. hole: 477mm
After the mounting feet have been slotted in to the
wall-mounting brackets, push the supporting feet be-
tween the sides of the mounting feet as shown in Fig.
3 and fix them in place using the fixing material sup-
plied.
All manuals and user guides at all-guides.com
Heater Dim. H
14/563 236
14/564 412
14/565 588
14/566 764
14/567 940
14/568 1116
Heater width - see „Technical Data"
Fig.1 Wall-mounting brackets / heater
1.
2.
Fig.2 Push in
mounting foot
Fig.3 Supporting foot
27