Olsberg 14/563 Notice D'utilisation page 32

22. Fill the bottom row with core bricks (G). The
bricks must be inserted on the left and pushed
to the right, slightly lifting the heating element
to do this.
Caution: Make sure when inserting the bricks
that a gap remains between the floor
insulation block and the front edge
of the floor plate so that the core
cover plate can be replaced.
23. Insert the second to fourth rows of core bricks
following the same pattern as in steps 19-22.
24. Insert the core brick cover (F) with the bev-
elled edge facing forward between the upper
row of the core bricks and the insulation.
25. Replace the insulation around the heating
elements on the connecting cabinet side of
the heater by pushing it firmly around the
ends of the elements.
32
All manuals and user guides at all-guides.com
G
Fig.14 Bottom row of core bricks
24.
F
Fig.15 Insert the core cover plate
25.