Items Supplied; Pushing On/Removing The Comb Attachments - SilverCrest SHBS 500 D4 Mode D'emploi

All manuals and user guides at all-guides.com

4. Items supplied

1 hair and beard trimmer
1 power unit 8
2 adjustable comb attachments 1:
Attachment 1: 1/3/6/9/12/15 mm
Attachment 2: 18/21/24/27/30/
33 mm
1 comb 12
1 scissors 13
1 cleaning brush 14
1 oil 15
1 storage pouch 16
1 set of operating instructions
5. Charging
NOTES:
• Before the device is used for the first
time, and during the following charging
procedures, the device should be
charged for 90 minutes in each case.
• When the batteries are almost empty,
the plug symbol 6 flashes in red. The
device can then only be used for a short
time without being connected to the
electricity supply.
1. Switch off the device with the on/off
switch 4 if necessary.
2. Connect the power unit 8 to the con-
nector 7 of the device.
3. Insert the power unit 8 into a readily
accessible wall socket whose voltage
matches the voltage stated on the rat-
ing plate.
4. The plug symbol 6 is lit red and the
battery is charged. When the battery is
fully charged, the battery symbol 5
flashes in blue. When the battery is ful-
ly charged, the device can be used for
approximately 60 minutes without be-
ing connected to the power supply.
6. Operation
NOTE: Figure D: For all applications hold
the shaver with an angle of 45° to your skin.
This does not apply to the „Thinning hair"
function, however.
Regardless of the charging state of the bat-
tery, the hair and beard trimmer can always
be mains-operated.
1. Before switching to mains operation,
ensure that the device is switched off.
2. Connect the power unit 8 to the con-
nection 7 of the device.
3. Insert the power unit 8 into a readily ac-
cessible wall socket whose voltage match-
es the voltage stated on the rating plate.
4. Switch on the device with the on/off
switch 4.
NOTE: When the hair and beard trimmer re-
mains connected to the wall socket after being
switched off, it will be charged automatically.
6.1 Pushing on/removing the
comb attachments
WARNING! Risk of injury!
Switch off the device before replacing
or changing the comb attachments 1.
Pushing on
• In order to attach a comb attachment 1,
push this over the guide rails on the side of
the device onto the comb attachment fas-
tener 9, until it is heard to click into place.
Removing
1. Push the comb attachment 1 upwards us-
ing a moderate amount of force. The
comb attachment 1 is released from the
comb attachment fastener 9.
2. Remove the comb attachment 1.
21
GB