Mounting Instructions - Lenze E82ZBR020 Mode D'emploi

Show/Hide Bookmarks
EDK82ZBX020
00454680
06/02
These Instructions
Ÿ describe the installation and handling of the potentiometer unit and switch unit.
Ÿ are only valid
- for potentiometer units with the designation E82ZBR020.
- for switch units with the designation E82ZBS020.
- together with the Operating Instructions of the corresponding controller.
Description
Ÿ The potentiometer unit E82ZBR020 allows the selection of an analog setpoint signal for Lenze
controllers through the function modules Standard I/O or Application I/O.
Ÿ The switch unit allows straightforward control of Lenze controllers through digital inputs of the
function modules Standard I/O or Application I/O (e. g. reversal of direction of rotation).
Range of application
Can be used with
Ÿ Frequency inverters 8200 motec
Ÿ Motor starters starttec
Items supplied
Potentiometer unit
1 Potentiometer unit mounted completely, 10 k Ω 1 switch unit, mounted completely
1 sticker for potentiometer settings
General data and application conditions
Enclosure
Dimensions [mm]
Possible mounting positions
The unit is mounted with an M20 bore.
Lenze Drive Systems GmbH, Postfach 10 13 52, D-31763 Hameln
l

Mounting Instructions

Potentiometer E82ZBR020
Switch unit E82ZBS020
IP55
( (+49) 5154 82-0, Fax Service: (+49) 5154 82-1112
Switch unit
1 sticker for switch settings
E82ZBX001
EDK82ZBX020 3.0