Changing The Settings - Dometic TankMate DTM05C Instructions De Montage Et De Service

All manuals and user guides at all-guides.com
Installing and connecting the device
➤ Rectify the error by checking whether each sensor is properly bonded to
the tank wall or whether the sensor is damaged. If a sensor is damaged,
you will not hear any noise when it is measuring. If you hear a noise from
the incorrect sensor, then you have to re-attach the sensor with the extra
sensor tape included in the supply.
I
NOTE
If you are unsure how to properly remove the incorrect sensor,
please contact the service centre in your country (addresses on
the back).
➤ Perform the test again until the green, yellow and red LEDs light up.
6.6

Changing the settings

The following settings can be adjusted:
z Interval between two measurements
z Tank material
z Type of gauge (optional)
You can also initiate a calibration.
30
TankMate DTM05C
EN