Copy To Camera; Network Menu - urmet domus 1093/061SVN Guide Rapide

2.3.1.14

Copy to camera

Select "Copy to camera" to select on which cameras to copy the following settings:

resolution

bit rate

frame rate

enable rec - schedule
Select "all" to copy the settings on all cameras. Select "Copy" and press "ENTER" to copy the settings. Confirmation of the
operation will be required: press "ENTER" again to confirm.
2.4

NETWORK MENU

 Description
Use this menu to configure the DVR according to the parameters of the Ethernet network to which it is connected.
Position the "Active Frame" on the "NETWORK" icon and press "ENTER".
IMPORTANT NOTE
The default IP address of the DVR is: 192.0.0.64. Use this menu to assign to the DVR an IP address which is not used

in the network by other devices to prevent conflicts.
Connect the DVR to the network after having correctly configured the IP address.

The following window will appear:
This page contains the basic menu settings.
Select "ADVANCED SETTINGS" and press "ENTER" to access advanced settings.
The selected item is highlighted.
Press arrows "◄►▲▼" to point the cursor to the various menu items.
Point the cursor to the required item and press "ENTER" to edit it. Use buttons "▲▼" to change the available options for the
selected menu item.
Select "CONFIRM" and press "ENTER" to make the changes effective.
Select "CANCEL" and press "ENTER" to cancel the changes.
Press "ESC" to go back by one step.
Press "ESC" several times until the configuration window closes to quit the configuration menu.
2.4.1 NETWORK MENU BASIC SETTINGS
2.4.1.1 IP
This menu option is used to set the DVR IP address.
Press "EDIT" and use the number keys 0-9 to enter the IP address. Use "◄►" to shift the cursor. Press "EDIT" to cancel. Press
"ENTER" to confirm or "ESC" to cancel.
The entered IP address must not be in conflict with other IP addresses.
If there is a DHCP server in the network, address "0.0.0.0" can be set. Save and reboot the device. While rebooting, the device
will connect to the server and obtain a dynamic IP address displayed in the IP field.
IMPORTANT NOTE
It is advisable to assign a static IP address to the device.
2.4.1.2 Port
This menu option is used to set the port number used for image transmission. The entered number must be higher than 2000.
The default setting is 8000.
Press "EDIT" and use number keys 09 to enter the port number. Use "◄►" to shift the cursor. Press "EDIT" to delete. Press
"ENTER" to confirm or "ESC" to cancel.
DS1093-029
All manuals and user guides at all-guides.com
Figure 30: network menu (basic settings)
45