Recording Menu; Hard Disk Full - urmet domus 1093/061SVN Guide Rapide

2.3

RECORDING MENU

 Description
This menu is used to edit the recording and configuration settings of each video signal.
Position the "Active Frame" on the "RECORDING" icon and press "ENTER".
The following window will appear:
The selected item is highlighted.
Press arrows "◄►▲▼" to point the cursor to the various menu items.
Point the cursor to the required item and press "ENTER" to edit it. Use buttons "▲▼" to change the available options for the
selected menu item.
Select "CONFIRM" and press "ENTER" to make the changes effective.
Select "CANCEL" and press "ENTER" to cancel the changes.
Press "ESC" to go back by one step.
Press "ESC" several times until the configuration window closes to quit the configuration menu.
IMPORTANT NOTE
Reboot the device to make the variations of some settings effective.
2.3.1 RECORDING MENU BASIC SETTINGS
2.3.1.1

Hard disk full

This option can be selected to define the recording method to be used when hard disk capacity is exceeded.
Possible options are: "overwrite" and "stop recording".
In overwrite mode ("overwrite" option), the recording writes over previously stored data.
If "stop recording" is selected, the recording will stop when the maximum capacity of the hard disk is reached.
If several hard disks are present in the DVR, the system will start writing on the SLAVE (secondary) disks when the MASTER
(main) disk is full. When the SLAVE disk is full, the system will start writing over the MASTER disk (if "overwrite" option is
checked) and then back on the SLAVE disks.
2.3.1.2 Select camera
This option is used to select the camera on which to edit the recording and configuration settings. Use "▲▼" to select the
camera. The respective camera will appear in the "Camera name" field (assigned in the "camera"  "name" field).
2.3.1.3 Stream type
This option can be used to select whether to record only images or both images and audio.
Possible options are: "Video" and "Audio&Video". Use "▲▼" to select the streaming type to be recorded.
IMPORTANT NOTE
For DVR DVS Ref.1093/061SVN, the "Video" and "Audio&Video" options are available.

2.3.1.4 Resolution
This menu option is used to set the resolution type to be reached for recording on the selected camera. In general, Urmet DVR
DVS devices are capable of supporting, according to the model, the following recording resolutions: "4CIF", "DCIF" "2CIF",
"CIF", and "QCIF". Use "▲▼" to select the resolution type.
Correspondence between code and respective resolution in PAL format are shown in the following table.
DS1093-029
All manuals and user guides at all-guides.com
Figure 28: recording menu
CODE
4CIF
DCIF
2CIF
CIF
QCIF
Table 2: correspondence between code and PAL resolution
42
RESOLUTION - PAL
704x576
528x384
704x288
352x288
176x144