Table des Matières
Publicité
Nozzle Hose
Tuyau de la tête d'aspiration
Boquilla de la manguera
Flat Screwdriver
Tournevis plat
Plano destornillador
Locking Tab
Release Hole
Trou de libération de
la languette de blocage
Bloqueando el agujero
del desbloquear de la
tabulatión
Removing Clogs
If the vacuum should become clogged:
➢ ➢ Ensure ON-OFF switch is OFF.
Suction
➢ ➢ Disconnect power cord from electrical
Inlet Cover
Couvercle de
l'entrée
d'aspiration
➢ ➢ Pull open suction inlet cover and
Cubierta de
aspiración
➢ ➢ Check the nozzle hose to make sure
➢ ➢ The nozzle hose may be removed at
➢ ➢ Check and replace any clogged
➢ ➢ Clean agitators.
Handle Removal
➢ ➢ Remove the screw that secures the
➢ ➢ Insert flat screwdriver into locking
➢ ➢ Remove handle assembly by pulling
- 42 -
outlet.
remove any clogs.
it is free from obstructions.
the wand attachment end in order to
remove clogs.
filters.
handle to the vacuum.
tab release hole located just in front
of the handle tube, pry screwdriver
toward the front of the vacuum. This
should release the handle locking tab
allowing the handle to be pulled from
the vacuum.
straight out of vacuum.
Publicité
Table des Matières
