Worx Sonicrafter WX679 Notice Originale page 8

WARNING: The vibration emission
value during actual use of the power
tool can differ from the declared value
depending on the ways in which the tool is
used dependant on the following examples
and other variations on how the tool is used:
How the tool is used and the materials being
cut or sanded.
The tool being in good condition and well
maintained
The use the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if
any anti vibration accessories are used.
And the tool is being used as intended by its
design and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately
managed.
WARNING: To be accurate, an
estimation of exposure level in the
actual conditions of use should also take
account of all parts of the operating cycle such
8
as the times when the tool is switched off and
when it is running idle but not actually doing
the job. This may significantly reduce the
exposure level over the total working period.
Helping to minimize your vibration exposure
risk.
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in
anti vibration accessories.
Avoid using tools in temperatures of 10
less.
Plan your work schedule to spread any high
vibration tool use across a number of days.
SAFETY INSTRUCTION FOR
CUTTING
1. Hold power tool by insulated
gripping surfaces, when performing
an operation where the cutting
accessory may contact hidden wiring
Oscillating Tool
or its own cord. Cutting accessory
contacting a "live" wire may make
exposed metal parts of the power tool
"live" and could give the operator an
electric shock.
2. Always wear a dust mask.
SYMBOLS
C or
O
To reduce the risk of injury, user
must read instruction manual
Double insulation
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Before working with your tool make
sure that no power cords will be
damaged.
Avoid danger of injury from the
sharp edges of the accessories.
Accessories can become very hot
while working, presenting danger
of burns!
Make sure the tool is unplugged
prior to changing accessories.
EN