AVG ARBM150SE Mode D'emploi page 36

11
install it on the reverse hole site, and
tighten into position (change it into lower
hinge-left) . Remove the lower hinge-left to
the left-bottom corner of cabinet, Then fix
it with 3 screws, finally install part
the left-bottom corner and right-bottom
corner of cabinet.
11. Rise the refrigerator upright and
carefully insert the lower door onto the
lower hinge-left pin and hold it in position.
Install middle hinge-left (provided in the
plastic accessory bag) and ensure the
lower door is in place.
on
④
12. Carefully insert the upper door onto
the middle hinge pin and hold in position.
Move the upper door to an appropriate
position, adjust the upper hinge-left
(provided in the plastic accessory bag)
and then fit the hinge pin into the hinge
hole at the top of the upper door to secure
it in place. Then fix the upper hinge part
with screws (Please carefully hold the
upper door when installing)
13. Install the temperature sensor part on
the upper hinge cover-left (provided in the
plastic accessory bag). Assemble the
upper hinge cover-left to match the hinge.
Install the door racks to original position.
Keep the upper hinge cover-right with the
appliance for future reference.