AVG ARBM150SE Mode D'emploi page 34

9
Note: If required, you may lay the refrigerator
on its back in order to gain access to the base,
you should rest it on soft foam packaging or
similar material to avoid damaging the
backboard of the refrigerator. To reverse the
door, follow the recommended steps.
1. Place the refrigerator upright. Open the
door to take out all door racks (to avoid
damage and then close the door.
Caution!
Please slightly squeeze the door rack from
two sides toward center and inside of door
rack, and then move it upward when taking
out the upper rack and lower rack.
2. Remove upper hinge cover-right
the right-top corner of cabinet. Remove the
temperature sensor from the cabinet and
right upper hinge cover, Install it on the
upper hinge cover-left (provided in the
plastic accessory bag). Unscrew the 3
screws which are used for fixing the
②
upper hinge-right (see the picture below)
and take down the upper hinge-right
3. Remove the upper door from the middle
hinge by carefully lifting the door straight
up. Then place the upper door on a
smooth surface with its panel upwards.
●
4. Remove screw ③ and take down stop
block ② and stopper ①, Install
replacement door stopper-left ④ and stop
f rom
①
block-left ⑤ (provided in the plastic
accessory bag) to the left side with screw
③. Keep part ① and part ② with the
appliance for future reference.
.
③