Functional Description - Haussmann CK104-CS Manuel De L'utilisateur

SAFETY INSTRUCTIONS FOR CUT-OFF SAW
„ Do not use the side of the abrasive wheel as a deburring grinder. This will
substantially weaken the wheel causing an unsafe condition. The wheel could
come apart sending fragments in all directions.
„ Do not alter in any way, shape, or form the upper and lower guards around the
abrasive cutting wheel.
„ DO NOT OPERATE THE SAW WITHOUT GUARDS IN PLACE.
„ NEVER PERFORM CUTTING OPERATIONS NEAR FLAMMABLE GAS OR
LIQUIDS.
„ DO NOT PERFORM ANY OPERATION FREEHAND.
„ ALWAYS CLAMP THE WORKPIECE FIRMLY AGAINST THE WORK TABLE.
Never attempt to hold the workpiece by hand. The abrasive wheel can seize in the
workpiece causing it to spin rapidly. This will cause loss of control of the workpiece
resulting in severe injuries or damage to the workpiece and Cut-off saw.
„ NEVER APPLY A COOLANT DIRECTLY TO THE WORKPIECE WHILE IT IS IN
CONTACT WITH THE ABRASIVE WHEEL. Coolant can weaken the makeup of
the abrasive wheels causing them to fail.
„ REDUCE THE RISK OF UNINTENTIONAL STARTING. Ensure the "ON/OFF"
switch is set to the "OFF" position before plugging the power cord into the AC
outlet.
„ NEVER LEAVE THE CUT-OFF SAW RUNNING UNATTENDED. WHEN
FINISHED WITH A CUTTING OPERATION, TURN "OFF" THE CUT-OFF SAW
AND WAIT UNTIL IT COMES TO A COMPLETE STOP.
SPECIFICATIONS
Voltage: 120 volts AC, 60 Hz
„
Current rating: 15 Amp
„
No-load speed: 3,800 RPM
„
Wheel diameter: 14"(35.6 cm)
„
Max cutting capacity: 4"(10 cm)
„
Adjustable fence: 45° left/right
„
ACCESSORIES
14" (35.6 cm) metal cut-off wheel
„
2 spare carbon motor brushes
„
Hex key
„

FUNCTIONAL DESCRIPTION

Figure 1 names the major components of the HAUSSMANN cut-off
saw.
1. Carbon brush cap
2. Safety guard
3. Vise handle
4. Rubber foot
5. Base
6. Blade
7. Top guard
8. Switch
9. Handle
20
CK104-CS
9
1
2
3
4
8
7
6
5
Fig.1