Electrolux EUG1343AOW Notice D'utilisation page 26

26 www.electrolux.com
Problem
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the FastFreeze,
or after changing the tem‐
perature.
Water flows on the floor.
Temperature cannot be
set.
DEMO appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
All manuals and user guides at all-guides.com
Possible cause
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
Food products are not
wrapped properly.
This is normal, no error
has occurred.
The melting water outlet is
not connected to the evap‐
orative tray above the com‐
pressor.
The FastFreeze function is
switched on.
The appliance is in demon‐
stration mode.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
The FastFreeze function is
switched on.
There is no cold air circula‐
tion in the appliance.
Solution
Refer to "Closing the door".
Wrap the food products
better.
The compressor starts af‐
ter a period of time.
Attach the melting water
outlet to the evaporative
tray.
Switch off FastFreeze
manually, or wait until the
function resets automati‐
cally to set the tempera‐
ture. Refer to "FastFreeze
function"
Keep the button pressed
for approximately 10 sec‐
onds until a long sound is
heard and display shuts off
for a short time.
Set a higher/lower temper‐
ature.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Open the door only if nec‐
essary.
Refer to "FastFreeze func‐
tion".
Make sure that there is
cold air circulation in the
appliance.