Keysight DAQ970A Guide D'utilisation page 24

1 Introduction to the Instrument
IP Address
You can enter a static IP address for the instrument as a four-byte integer expressed in dot notation. Each byte is a
decimal value, with no leading zeros (for example, 169.254.2.20). Refer to
Notation for further details.
Step Front panel
1 Press [Home] > User Settings > I/O > LAN Settings > Modify Settings.
Set the first softkey to
IP address.
2 If you change this parameter, you must press
[Done] > [Apply Changes] for the change to take effect.
– If DHCP is on, it attempts to assign an IP address to the instrument. If it fails, Auto-IP attempts to assign an IP
address to the instrument.
– Contact your LAN administrator to obtain an IP address.
– This setting is non-volatile, it will not be changed by cycling power, factory reset (*RST command), or instru-
ment present (SYSTem:PRESet command).
Subnet Mask
Subnetting allows the LAN administrator to subdivide a network to simplify administration and minimize network
traffic. The subnet mask indicates the portion of the host address used to indicate the subnet.
Step Front panel
1 Press [Home] > User Settings > I/O > LAN Settings > Modify Settings.
Set the first softkey to
subnet mask address.
2 If you change this parameter, you must press
[Done] > [Apply Changes] for the change to take effect.
– Contact your LAN administrator to obtain an IP address.
– This setting is non-volatile, it will not be changed by cycling power, factory reset (*RST command), or instru-
ment present (SYSTem:PRESet command).
24
Manual and press IP Address to set the desired
Manual and press Subnet Mask to set the desired
More about IP Addresses and Dot
Remote interface
SYSTem:COMMunicate:LAN:IPADdress
SYSTem:COMMunicate:LAN:UPDate
Remote interface
SYSTem:COMMunicate:LAN:SMASk
SYSTem:COMMunicate:LAN:UPDate
Keysight DAQ970A/DAQ973A User's Guide