Safety Instructions - Hilti PR 30-HVS Mode D'emploi

Weight
Dimensions (L x W x H)
PUA 81 AC adapter
AC supply
AC frequency
en
Rated power
Rated voltage
Operating temperature range
Storage temperature range (dry)
Weight
Dimensions (L x W x H)

5 Safety instructions

5.1 Basic information concerning safety
In addition to the information relevant to safety given
in each of the sections of these operating instructions,
the following points must be strictly observed at all
times.
5.2 General safety rules
a) Do not render safety devices ineffective and do
not remove information and warning notices.
b) Stay alert, watch what you are doing and use com-
mon sense when operating the machine. Don't
use the machine when you are tired or under the
influence of drugs, alcohol or medication. A mo-
ment of inattention while operating machines may
result in serious personal injury.
c) Keep laser tools out of reach of children.
d) Failure to follow the correct procedures when open-
ing the tool may cause emission of laser radiation in
excess of class 2 or, respectively, class 3. Have the
tool repaired only at a Hilti service center.
e) Do not operate the tool in explosive atmospheres,
such as in the presence of flammable liquids,
gases or dust. Tools and appliances create sparks
which may ignite the dust or fumes.
f) (Statement in accordance with FCC §15.21):
Changes or modifications not expressly approved
by the manufacturer can void the user's authority to
operate the equipment.
g) Use of setting-up / adjusting devices and equipment
or operating procedures other than those specified in
these instructions may lead to exposure to hazardous
radiation.
h) Check the condition of the tool before use. If the
tool is found to be damaged, have it repaired at a
Hilti service center.
28
All manuals and user guides at all-guides.com
0.3 kg
160 mm x 45 mm x 36 mm
115...230 V
47...63 Hz
36 W
12 V
+0...+40°C
-25...+60°C
0.23 kg
110 mm x 50 mm x 32 mm
i)
j)
k) Check the tool before using it for important meas-
l)
m) When the tool is brought into a warm environment
n) If mounting on an adapter, check that the tool is
o) Keep the laser exit aperture clean to avoid meas-
p) Although the tool is designed for the tough condi-
q) Although the tool is protected to prevent entry
r)
s)
t)
u) Ensure that the workplace is well lit.
v)
Maintain the machine carefully. Check for mis-
alignment or binding of moving parts, breakage
of parts and any other condition that may affect
the machine's operation. If damaged, have the
machine repaired before use. Poor maintenance is
the cause of many accidents.
The user must check the accuracy of the tool
after it has been dropped or subjected to other
mechanical stresses.
uring work.
Check the accuracy of the measurements several
times during use of the tool.
from very cold conditions, or vice-versa, allow it
to become acclimatized before use.
screwed on securely.
urement errors.
tions of jobsite use, as with other optical and elec-
tronic instruments (e.g. binoculars, spectacles,
cameras) it should be treated with care.
of dampness, it should be wiped dry each time
before being put away in its transport container.
Keep the electrical contacts dry (protect from rain
or dampness).
Use the AC adapter only for connecting to the AC
supply.
Check to ensure that the tool and AC adapter do
not present an obstacle that could lead to a risk
of tripping and personal injury.
Check the condition of the extension cord and
replace it if damage is found. Do not touch the AC
adapter if the extension cord or AC adapter are
damaged while working. Disconnect the supply
cord plug from the power outlet. Damaged supply