Parts Identification; Power Switch; Liquid-Crystal Display - Sony WRT-805A Mode D'emploi

Parts Identification

1

POWER switch

Antenna
2
Liquid-crystal
B A T T
display
C H
S E T
3
SET button
+
–
4
+/– buttons
Location of parts
All manuals and user guides at all-guides.com
5
Audio input
connector
6
INPUT level
switch
7
PHASE switch
8
Belt clip
Battery
compartment
(See page 9.)
1 POWER switch
Turns the power of the transmitter ON or OFF.
When you set this switch to ON without holding any other
button, the transmitter is set to normal Transmit mode and
transmits the signal of the selected channel.
When you set this switch to ON while holding the SET
button down, Setting mode is initiated. No signal is
transmitted in Setting mode.
For setting mode, see "Settings" on page 12.
Note
Be sure to connect a microphone or guitar cable before
turning the power ON.

2 Liquid-crystal display

a b
AF
a AF (audio input) indication
Lights when an audio signal over the reference level is being
supplied.
c
RF BATT
CH
d
7