Technical Data - IB RUBINETTI INDUSTRIA 396 Notice De Montage

EN

TECHNICAL DATA

Minimum dynamic pressure:_______________________________________________________________0.5 bar
Maximum operational pressure:______________________________________________________________5 bar
Recommended operational pressure:_______________________________________________________1-5 bar
It's recommended to use a pressure reducer in case of
static pressure superior than 5 bar inside the waterpipe.
Maximum hot water temperature:____________________________________________________________80°C
INSTALLATION, MAINTENANCE AND PRELIMINARY CHECKING PROCEDURE
In order to get your device work correctly and fi ne in time, must ensure compliance with the mode
of installation and maintenance described in this booklet. Relying on a qualifi ed plumber. Make sure
that the system is free from all debris and impurities existing.
INSTALLATION
Fig. 1: Make the hole on the surface for positioning the spout MIN Ø27 mm - 1.06 in and MAX Ø33
mm - 1.29 in. Insert the rod into the base by positioning the fl at gasket under it.
Insert the rod into the hole and fi x it in the underlying part with the fi xing kit, ending the locking by
tightening the screws.
Fig. 2: For the mixer and the diverter, remember that the maximum thickness of the surface must be
15 mm - 0.59 in.
Fig. 3: Make the hole on the surface for positioning the mixer, MIN Ø42 mm - 1.65 in and MAX Ø45
mm - 1.77 in. Pre-tighten the screws on the mixer unit. Positioning the ring and the gasket. Insert the
mixer unit from under the surface. Place the gasket underneath the base, screw the base onto the
mixer unit that protrudes from the surface. Complete the locking by tightening the screws.
Fig. 4: Position the handle on the control rod, screwing the grain until it is completely blocked.
Insert the plug covering the hole.
Repeat steps 2 to 4 to install the diverter.
Fig. 5: connect the mixer with the diverter with the quick connection pipe.
Fig. 6: Make the hole on the surface for positioning the shower support, MIN Ø27 mm - 1.06 in and
MAX Ø33 mm - 1.29 in. Insert the rod inside the hole, by positioning the fl at gasket underneath the
base. Fix it at the bottom using the appropriate kit, complete the locking by tightening the screws.
Connect the hose to the shower, taking care to insert the fl at gasket.
Insert the rest of the hose under the fl oor, through the shower support itself.
Fig. 7: Connect the mixer to the water supply with the hoses. Connect the spout to the diverter outlet
with the hose. Connect the shower hose to the diverter. Follow the instructions given in the fi gure.
After connecting the body to the system, turn on the stopcocks and check that the mixer tap unit
operates correctly. Keep the tap pressurised for a few minutes checking eventual leaks.
CLEANING
In order to obtain a correct cleanliness, exclusively wash them with soap and water, rewash and dry
them with a soft towel and deerskin. Avoid the usage of alcohol, solvents, solid or liquid detergents
which contain corrosive or acidic substances, abrasive sponges, swab with metallic strings because
they could irreversibly compromise the surfaces.
THE USAGE OF THIS KIND OF DETERGNETS DURING THE CLEANING OF THE MIXER EXCLUDE IB
RUBINETTERIE FROM ANY WARRANTY OBLIGATION.
All manuals and user guides at all-guides.com