Siemens SITRANS F FCS400 Guide Rapide page 7

B: Connecting at transmitter
1. Remove lock screw and remove lid.
2. Remove one of the blind plugs and fit cable gland.
3. Remove cap and ferrule from cable gland and slide onto cable.
4. Push cable through open gland; anchor cable screen and wires with clamp bar.
5. Connect wires to terminals according to list below.
Terminal number
1
2
3
4
6. Assemble and tighten cable gland.
7. Remove o-ring from lid.
8. Reinstate lid and screw in until mechanical stop. Wind back lid by one turn.
9. Mount o-ring by pulling it over the lid and tighten lid until you feel friction from the o-ring on both sides. Wind lid by one
quarter of a turn to seal on the o-ring.
10. Reinstate and tighten lid lock screw
C: Connecting at sensor DSL
1. Remove lock screw and remove DSL lid.
2. Undo the flexible strap.
3. Disconnect sensor connection from DSL cassette.
4. Loosen mounting screw using a TX10 Torx driver and remove DSL cassette from housing.
5. Remove cap and ferrule from cable gland and slide onto cable.
6. Push cable through open gland; anchor cable screen and wires with clamp bar.
7. Remove terminal block from DSL cassette.
8. Connect wires to terminals according to list below.
Terminal number
1
2
3
4
FCS400 sensor
A5E03649755-008, 05/2014
Description
+15 VDC
0 VDC
B
A
Description
+15 VDC
0 VDC
B
A
Wire color (Siemens)
Orange
Yellow
White
Blue
Wire color (Siemens)
Orange
Yellow
White
Blue
7