Valor 755CFK Manuel D'installation Et D'utilisation page 8

11. Thread the fan's electrical cord out of the firebox
through the appliance's side access hole.
12. At the front of the appliance, pull up the fixing tab
from the bottom right hand side of the appliance.
13. Fasten the control box tab to the fixing tab with a
screw.
14. Fasten the fan wires to the bottom of the firebox
with the cable retainer supplied.
8
15. Under the burner module plate, right behind the
valve, there is a small bracket with two clips. Slide
the thermal switch in the bracket. If the bracket clips
are too tight, open them up with a screwdriver's
blade.
16. Reinstall the burner making sure the wiring of the
fan is out of the way (12 screws).
17. Plug the electrical cord to a wall outlet.
18. Reinstall the log support (4 screws), the liner panels,
the fuel bed and the window.
19. The fan and controls are factory tested to ensure
fan operation but, with the control box energized,
check that the fan operates correctly. This will
require letting the fireplace come up to operating
temperature for approximately 10–15 minutes.
Ensure that the variable speed control is turned to
the ON position at HIGH.