Valor 755CFK Manuel D'installation Et D'utilisation page 5

Installation with Valor Models G3 739 (2 methods)
(This kit cannot be installed on models 738)
Method A—Installing from the rear of the
appliance
fan
cavity
electrical
outlet
1. Remove the plate at the bottom rear of the
appliance (7 screws).
2. Fix the fan mounting plate to the rear plate (2
screws).
Method A—Overview
3. Place the fan on the fan monting plate as far back as
possible against tabs. Center it in width so that the
fastening stud on the mounting plate lies between
the fan's support legs. The fan should rest against
the two tabs of the mounting plate and against the
two tabs of the rear panel.
4. Fit the fan retaining clamp between the fan legs and
push it all the way under the tab at the back of
the mounting plate placing the front end over the
threaded stud. Bring the retaining clamp slightly
forward to avoid the offset contacting the mounting
bracket.
RIGHT SIDE VIEW
Mounting
Fan
plate tab
Retaining clamp
5. Fasten the retaining clamp to the threaded stud with
the wing nut and washer provided.
6. Connect the thermal switch to the fan speed control
box.
5