Valor 755CFK Manuel D'installation Et D'utilisation page 6

7. From the rear of the appliance, find the thermal
switch fixing bracket located under the burner
behind the valve. Slide the thermal switch in the
bracket. If the bracket tabs are too tight, open them
up with a screwdriver's blade.
8. Thread the fan's electrical cord into the firebox and
out through the appliance's side access hole.
6
9. Slide the control box forward in the firebox between
the valve and the firebox wall.
10. Insert the fan and secure the rear plate to the
appliance's rear panel (7 screws).
11. Finish the installation of the fireplace following the
appliance's installation manual.
12. From the front of the appliance, pull up the fixing
tab from the bottom of the appliance located at the
right of the valve.
13. Fasten the control box tab to the fixing tab with a
screw.
14. Plug the electrical cord to a wall outlet.
15. The fan and controls are factory tested to ensure
fan operation but, with the control box energized,
check that the fan operates correctly. This will
require letting the fireplace come up to operating
temperature for approximately 10–15 minutes.
Ensure that the variable speed control is turned to
the ON position at HIGH.