GE PCGS910 Manuel Du Propriétaire page 15

Using the clock, timer and control lockout.
Make sure the clock is set to the
correct time of day.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59 minutes.
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
To Set the Timer
TIMER
Touch the pad.
Touch the number pads until the
amount of time you want shows
in the display. For example, to set
2 hours and 45 minutes, touch 2, 4
and 5 in that order. If you make a
TIMER
mistake touch the
begin again.
Touch the START pad.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by
touching the TIMER pad, then touch
the number pads until the time you
want appears in the display.
To Cancel the Timer
Touch the TIMER pad twice.
Control Lockout
(only some models)
Your control will allow you to lock out the touch
pads so they cannot be activated when touched
or while cleaning the glass panel.
To lock/unlock the controls:
Touch the 9 and 0 pads at the same
time for 3 seconds, until the control
beeps twice. The display will show
LOC
continuosly at the time of day
if not blanked out
To unlock the control, touch the 9
and 0 pads at the same time for 3
seconds, until the display shows
LOC .
Touch the CLOCK pad.
Touch the number pads.
Touch the START pad.
After touching the START pad, SET disappears;
this tells you the time is counting down, although
the display does not change until one minute has
passed. Seconds will not be shown in the display
until the last minute is counting down.
When the timer reaches :00 , the
control will beep 3 times followed
pad and
by one beep every 6 seconds until
the TIMER pad is touched.
The 6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
touching the TIMER pad and then
touching the number pads to enter the
new time you want.
NOTE: All cooking and timing functions will be
cancelled when locking out the control.
NOTE: Some models have a
OUT / GAS RANGE LOCKOUT / RANGE
LOCKOUT
pad. Touch and hold it for seconds
to lock/unlock.
www.GEAppliances.ca
CONTROL LOC CONTROL LOCK
3
15