Binatone Solo Plus Mode D'emploi page 8

2 INSTALLING YOUR PHONE
2.1 Connecting the Base Station
1) Plug the power cable and telephone
line cord into the base station.
2) Plug the power adapter into a
120Vac, 60Hz power socket, and the
telephone line cord into a telephone
line socket.
Warning:
Always use the cables provided in the box.
Use only the supplied adaptor. Using other power cables may damage
the unit.
Note:
Place the base unit within easy reach of the power socket. Never try to
lengthen the power cable.
The base station needs power for normal operation, and the cordless
handsets will not function unless the base station is plugged in.
2.2 Installing and Charging the Rechargeable Batteries
1) Insert the 2 supplied batteries into the
battery compartment, aligning the
batteries with the markings inside
battery compartment.
Warning: Use only the supplied NiMH
rechargeable batteries.
2) Place the back cover over the back of
the handset and press down until it
clicks into place.
3) Place the handset on the base and
charge for 15 hours before using it for
the first time.
• The handset will give a double beep when it is properly placed on
the base or charging pod.
The battery charging indicator on the base or charging pod will
•
light up to when charging.
Note: The handset may become warm when the batteries are being
charged or during prolonged periods of use. This is normal and does not
indicate a fault.
To the mains
power socket
8
To the
telephone
line socket