Binatone Solo Plus Mode D'emploi page 46

12 Help
The icon is not scrolling when the handset is placed on the base
Handset is not properly seated on the base cradle -
readjust the handset on the base.
Dirty contact - clean the charge contacts by wiping with an alcohol
moistened cloth.
Battery is full - charging is not necessary at this time.
No dial tone
If there is no base power, check the connections. Reset
The phone by unplugging then plugging it back into an electrical
outlet.
If the handset batteries are empty, recharge the battery pack for at
least 24 hours.
Move the handset closer to the base.
Be sure to use only the provided telephone cords.
Poor audio quality
If the base is too close to electrical appliances, reinforced
concrete walls, or metal door frames, move the base from these
areas.
No ring tone
The ringer may be off.
The volume may need to be increased.
Caller ID does not work
Check your subscription with your network operator.
If you subscribe to high-speed Internet service (Digital Subscriber Line
- DSL) through your telephone lines, you must install a DSL filter
between the telephone base and the telephone wall jack. The filter
will prevent noise and caller ID problems caused by DSL interference.
Please contact your DSL service provider for more information about
DSL filters.
A phonebook entry cannot be stored
The phonebook is full. Delete an entry to free memory
46