Binatone Solo Plus Mode D'emploi page 41

11.2 Answering Machine Settings
11.2.1 Set the Ring Delay
You can select the number of rings before the answering machine
answers a call and starts playing the outgoing message (OGM).
You can set the delay from 2 to 7 rings, or TOLL SAVER.
IMPORTANT: If your network voice messaging system is enabled, you
must set your RING DELAY to less than 6 rings; otherwise the network
service will answer all your calls before the answering machine of your
telephone and prevent it from recording any messages.
1. From the home screen, press
2. Press +
3. Press +
select.
M
4. Press
+
5. Press
and then press
• A confirmation tone will play.
O
6. Press
Note: If you select TOLL SAVER, the answering machine will answer an
incoming call on the fifth ring if you have no previous new messages and
on the third ring if you do.
When you call your answering machine to check messages, if it does not
answer on the third ring, then you can hang up immediately because this
indicates that you have no new messages. This feature can save you the
cost of a long-distance call when you check your messages remotely.
11.2.2 Activate/Deactivate Remote Access
Note: The remote control access is already set to activated, so you can
check the messages on your answering machine when you are away
from home by calling from another phone.
The SECURITY CODE is used for accessing the answering machine
remotely. If your answering machine is off, you must change your
SECURITY CODE from its default 0000 before you can use the remote
access feature to turn on your answering machine.
-
/ to ANS. SYSTEM and then press
-
/ to ANS. SETTING and then press
to select RING DELAY.
-
/ to select 2 RINGS – 7 RINGS or TOLL SAVER
M
to confirm.
to return to standby mode.
M
.
41
M
to select.
M
to