Starting Operation - Bosch GWS 11-125 CIH Professional Instructions D'emploi

All manuals and user guides at all-guides.com
OBJ_BUCH-194-002.book Page 13 Monday, February 26, 2007 11:14 AM
Rotating the Machine Head
Before any work on the power tool itself, pull
the mains plug.
The machine head can
be
respect
machine housing in
90° steps. In this man-
ner, the On/Off switch
can be brought into a
more convenient posi-
tion for special work-
ing situations, e. g., for
cutting
using the cutting guide
with dust extraction
protection
20/cut off stand or for
left-handed persons.
Completely unscrew the four screws. Rotate the
machine head carefully, without removing it from
the housing, to the new position. Screw in and
tighten the four screws again.
Operation

Starting Operation

Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the type plate of the
power tool.
When operating the power tool with power from
mobile generators that do not have sufficient reserve
capacity or are not equipped with suitable voltage
control with starting current amplification, loss of per-
formance or untypical behavior can occur upon
switching on.
Please observe the suitability of the power generator
being used.
Switching On and Off
To start the power tool, press the On/Off switch 4
forward and then down.
To lock-on the pressed On/Off switch 4, push the
On/Off switch 4 further forward.
To switch off the power tool, release the On/Off
switch 4, or when it is locked, briefly press the On/Off
switch 4 and then release it.
1 609 929 L07 • 26.2.07
Switch Version without Lock-on
(country-specific):
To start the power tool, press the On/Off switch 4
forward and then down.
To switch off the power tool, release the On/Off
switch 4.
rotated with
to the
Check grinding tools before using. The
grinding tool must be mounted properly and
be able to move freely. Carry out a test run
for at least one minute with no load. Do not
use damaged, out-of-center or vibrating
grinding tools. Damaged grinding tools can
burst and cause injuries.
operations
Kickback stop
In case of a sudden drop in speed,
e. g. jamming while carrying out a sep-
guard
arating cut, the power supply to the
motor is interrupted.
To restart the operation, switch the
On/Off switch 4 to the Off position
and start the machine again.
Restarting protection
The restarting protection feature prevents uncon-
trolled restarting of the machine after an interruption in
the power supply.
To restart the operation, switch the On/Off switch
4 to the Off position and start the machine again.
Reduced starting current
The electronic reduced starting current limits the
power consumption when switching the tool on and
enables operation from a 16 ampere fuse.
Constant Electronic Control
Constant electronic control holds the speed constant
at no-load and under load, and ensures uniform work-
ing performance.
English | 13