Starting Operation - Bosch GWS Professional 5-100 Notice Originale

All manuals and user guides at all-guides.com
OBJ_BUCH-704-003.book Page 15 Thursday, July 24, 2008 1:02 PM
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in con-
nection with wood-treatment additives (chro-
mate, wood preservative). Materials contain-
ing asbestos may only be worked by
specialists.
– Use dust extraction whenever possible.
– Provide for good ventilation of the working
place.
– It is recommended to wear a P2 filter-class
respirator.
Observe the relevant regulations in your coun-
try for the materials to be worked.
Operation

Starting Operation

Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine.
Speed preselection (GWS 6-100 E/GWS 6-115 E/GWS 6-125 E)
The required speed can be preselected with the thumbwheel 4 (also while running).
The data in the following table are recommended values.
Material Application
Metal Removing paint
Wood, metal Brushing, rust removal
Metal, masonry Grinding
Metal Rough grinding
Masonry, stone Cutting
Bosch Power Tools
When operating the machine with power from
mobile generators that do not have sufficient re-
serve capacity or are not equipped with suitable
voltage control with starting current amplifica-
tion, loss of performance or untypical behavior
can occur upon switching on.
Please observe the suitability of the power gen-
erator being used, particularly with regard to the
mains voltage and frequency.
Switching On and Off
To start the power tool, push the On/Off switch
2 forwards.
To lock the On/Off switch 2, press the On/Off
switch 2 down at the front until it latches.
To switch off the power tool, release the On/Off
switch 2 or, if it is locked, briefly push down the
back of the On/Off switch 2 and then release it.
Check grinding tools before using. The grind-
ing tool must be mounted properly and be
able to move freely. Carry out a test run for
at least one minute with no load. Do not use
damaged, out-of-centre or vibrating grinding
tools. Damaged grinding tools can burst and
cause injuries.
Accessory
Sanding disc
Cup brush, sanding disc
Grinding disc
Grinding disc
Cutting disc and cutting guide
(Cutting masonry/stone is permitted
only with use of the cutting guide)
English | 15
Thumbwheel
Position
2 – 3
3
4 – 6
6
6
1 609 929 L34 | (24.7.08)