Technical Data; Service / Warranty - Gardena SmallCut 300 Mode D'emploi

Fault
The Turbotrimmer
no longer cuts.
In the event of other faults please contact GARDENA Service.
A Repairs should only be carried out by GARDENA service centres or dealers
authorised by GARDENA.

8. Technical Data

Turbotrimmer
Motor power consumption
Mains voltage /
mains frequency
Filament thickness
Cutting width
Filament supply
Filament feed
Weight
Rpm of filament cassette
Work area related emission
characteristic value L
Noise level L 2)
WA
Hand / arm vibration a
Measuring method according to 1) EN 786 2) directive 2000 /14 / EC

9. Service / Warranty

14
All manuals and user guides at all-guides.com
Possible cause
Filament cassette empty.
Cutting filament too short or the
automatic filament extension
does not work.
Cutting filament inside the
cassette or fused.
SmallCut 300 (Art. 8845)
300 W
230 V / 50 - 60 Hz
1.5 mm
230 mm
10 m
Fully automatic
1.8 kg
11,100 rpm
1) 85 dB (A)
pA
measured 94 dB (A) / guaranteed 96 dB (A)
1) < 2.5 m / s 2
vhw
GARDENA guarantees this product for 2 years (from date of
purchase). This guarantee covers all serious defects of the unit
that can be proved to be material or manufacturing faults. Under
warranty we will either replace the unit or repair it free of charge
if the following conditions apply:
• The unit must have been handled properly and in keeping with
the requirements of the operating instructions.
• Neither the purchaser or a non-authorised third party have
attempted to repair the unit.
Remedy
v Replace the filament cassette
(see 6. Maintenance
"Replacing the filament
cassette" ).
v Pull the filament out of the
cassette manually.
v Release filament that has
disappeared into the
cassette or fused together.