Olsson and Brothers STROOT SPECTRE Mode D'emploi page 24

EN
E-SCOOTER ASSEMBLY
• Place the scooter on a flat surface.
• Open the e-scooter folding lever vertically. Insert the upper bar into the head,
fitting it. This operation must be carried out with the tube in ver- tical position.
• Verify that the cables are connected as shown in the figure. Then tighten the screws
with an exagonal key to fix the head to the bar, making sure they are perfectly adjus-
ted, this step is very important for steering.
• After the assembly, check that the display is working properly by swit- ching on
the equipment.
Sesure the scooter standpipe
1
and open the parking bracket.
Use the hex wrench in the pac-
3
king box to lock the screws on
both sides.
Your new e-scooter must be assembled according to the previous steps, as shown in the
figure. Make sure that you have completed all the steps during assembly.
24
IInstall the crossbar and
2
standpipe..
After the completlon of the
4
installation to carry out switch
detection.