Manual Operation; Remote Operation; Safety Cut-Off - Ruby Fires Elski Mode D'emploi

MANUAL OPERATION

- Press the POWER button once to turn on the appliance and the fire effect. A red indicator light will
appear to indicate that the function is ON.
- Press the button to choose a brighter or dimmer setting for the flame display and embers.
- Press several times to go through the different settings.
- Press the HEATING I button once for the low heat setting; press again to switch off the heat setting.
- Press the HEATING II button once for the high heat setting; press again to switch off the heat setting.

REMOTE OPERATION

- It takes some time for the receiver to respond to the transmitter.
Do not PRESS the buttons more than once within two seconds for correct
operation.
- Press the POWER button once to turn on the appliance and the fire effect.
A red indicator light will appear to indicate that the function is ON.
- Press the button to choose a brighter or dimmer setting for the flame display
and embers. Press several times to go through the different settings.
- Press the HEATING I button once for the low heat setting; press again to
switch off the heat setting.
- Press the HEATING II button once for the high heat setting; press again to
switch off the heat setting.

SAFETY CUT-OFF

- This appliance is fitted with a safety cut-off which will operate if the fireplace heater over- heats
(e.g. due to blocked air vents). For safety reasons, the fireplace heater will NOT automa- tically reset.
- To reset the appliance, disconnect the appliance from the mains supply for at least 15 minutes.
Reconnect the supply to the mains and switch on the appliance.