KENMORE ELITE 622.60002 Guide D'utilisation Et D'entretien page 28

All manuals and user guides at all-guides.com
Troubleshooting
PROBLEM SOLUTION
Oven door will not unlock after • Oven interior is still hot. Allow about one hour for the oven to cool after the
self-clean cycle.
• The control and door may be locked. See page 11.
Smoothtop surface shows 1. Tiny scratches or abrasions
wear.
2. Metal marks
3. Brown streaks and specks
4. Areas with a metallic sheen
5. Pitting or flaking
Moisture collects on oven • This is normal when cooking foods high in moisture.
window or steam comes from • Excessive moisture was used when cleaning the window.
oven vent.
There is a strong odor or light • This is normal for a new range and will disappear after a few uses. Initiating a clean
smoke when oven is turned on.
• Turning on a ventilation fan will help remove the smoke and/or odor.
• Excessive food soils on the oven bottom. Use a self-clean cycle.
Fault Codes • BAKE or LOCK may flash rapidly in the display to alert you if there is an error
• If the oven is heavily soiled, excessive flareups may result in a fault code during
Noises may be heard. • The oven makes several low level noises. You may hear the oven relays as they go on
• As the oven heats and cools, you may hear sounds of metal parts expanding and
There are no beeps and • Oven may be in Sabbath Mode. See page 18.
no display.
completion of a self-clean cycle. The door can be opened when LOCK is not
displayed.
• Make sure cooktop and pan bottom are clean. Do not slide glass or metal pans
across top. Make sure pan bottom is not rough. Use the recommended
cleaning agents. See page 23.
• Do not slide metal pans across top. When cool, clean with Cooktop
Cleaning Creme. See page 23.
• Remove spills promptly. Never wipe with a soiled cloth or sponge. Make sure
cooktop and pan bottom are clean.
• Mineral deposits from water and food. Use recommended cleaning agents.
See page 23.
• Remove sugary boilovers promptly. See page 23.
cycle will "burn off" the odors more quickly.
or a problem. If BAKE or LOCK appear in the display, press STOP pad.
If BAKE or LOCK continue to flash, disconnect power to the appliance.
Wait a few minutes, and then reconnect power. If the flashing still continues,
disconnect power to the appliance and call an authorized servicer.
cleaning. Press the STOP pad and allow the oven to cool completely, wipe out
excess soil, then reset the clean cycle. If the fault code reappears, contact an
authorized servicer.
and off. This is normal.
contracting. This is normal and will not damage your appliance.
27