weasy TRC50 Manuel D'utilisation page 21

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 23
TROUBLESHOOTING
Problem
1
LED stays Red
after power on.
TRC50is moving
2
backwards after being
started.
keeps blinking
3
GREEN after 5 hours
charging.
The side brush
4
becomes crooked, not
good to sweep.
5
Cannot start the W270.
TRC50circles around
6
only.
※ If the solution can not solve the problem, please contact your local dealer for
service.
Possible Cause
1. Battery Low condition.
2. The wheels stuck.
TRC50is on the darker or
dull floors (it means the
reflectivity of floor is bad).
The power input could have
been interrupted during
charging.
Being used for a long time.
1. The battery is not
installed properly.
2. Battery power is low.
One of the wires of the
wheels is loosened.
Solution
1. Recharge the cleaner.
2. Remove
TRC50from
obstacles.
Please adjust the three
windows of anti-cliff sensor.
(Please refer to page 9.)
As long as the total charging
time of this cycle is over 5
hours, you could start it for
cleaning.
If it becomes crooked, you
could soak it in hot water to
have it recover to its original
shape.
1. To install the battery
properly, please refer to
page 7 for battery
installation.
2. Have the battery fully
charged.
Open the wheel cover and
connect the loosened wire of
the wheel set properly or
contact your local dealer for
service.

Publicité

Table des Matières
loading

Produits Connexes pour weasy TRC50

Table des Matières