Maintenance And Cleaning - Bosch AHS 2000 Instructions D'emploi

Trimming hedges
Assume a secure posture and always use both hands to hold the unit at
the handles. No animals or other persons are to be in the work area.
Always route the extension cord away to the rear.
Shaping
The hedge should be trimmed to achieve
a trapezoidal form, that is, it should widen
toward the bottom on both sides. This
improves the penetration of light to the
lower extremities. A general guideline is:
Approx. 10 cm slant for each 1 meter of
bush height.
The top of the shrub can also be given a
rounded or column-shape.
Cutting sequence
First cut both sides, starting at the bottom
and working to the top; this prevents
cuttings from falling into the area whereyou
are still working.
Then trim the top: Where the branches have
grown extremely long, cut back the hedge
in several stages.
Benefit: Short cuttings are better suited for
composting.
Optimum trimming times
Hedges with green leaves are best trimmed
in June and October, evergreens in April
and August, while conifers and other fast-
growing shrubs should be trimmed about
every six weeks from May onward.
10 cm





















 




General information
When older hedges are to be cut back a substantial amount, use pruning shears
to trim thicker branches to the desired length before starting work with the hedge
trimmer. To shape precisely, run a taught line between the extreme edges of the
hedge and then trim along it. Ensure that the blade does not come into contact
with any objects made of hard material that could damage it, such as fencing wire
or metallic plant supports.

Maintenance and Cleaning

Always disconnect the plug from the power socket before carrying out
any work on the appliance.
Never use water to clean or spray off the unit.
Store the unit in a dry place.
Inspect your hedge trimmer before each use.
It is essential that any damage to the blade rail be professionally repaired before
the unit is used. Only use extension cords in good condition to connect your
hedge trimmer.
The blade rail should be cleaned and treated with maintenance spray (accessories)
after each use. When a job lasts for a longer period of time, we recommend that the
blade rail also be treated with maintenance spray at regular intervals during operation.
We recommend the storage sheath (accessories) for storage and transport.
The storage sheath can be secured to the wall with two screws.
Always keep the ventilation slots unobstructed and clean.
If the machine should happen to fail despite the care taken in manufacture and
testing, repair should be carried out by an authorised customer services agent
for Bosch power tools. For all correspondence and spare parts orders, always
include the 10 digit order number of the machine!
WARNING
Important instructions for connecting a new 3-pin plug to the 2 wire cable.
The wires in the cable are coloured according to the following code:
Do not connect the blue or brown wire
to the earth terminal of the plug.
Important: If for any reason the
moulded plug is removed from the
cable of this machine it must be
disposed of safely.
strain relief
To be fitted
live = brown
by qualified
neutral = blue
professional only
10