Maintenance And Service; Maintenance And Cleaning; Blade Maintenance; After Use/Storage - Bosch AGS 7,2 LI Notice Originale

All manuals and user guides at all-guides.com
OBJ_BUCH-1077-004.book Page 26 Wednesday, July 6, 2011 9:54 AM
26 | English
Recommended times
– Cut hedges with deciduous leaves in June
and October.
– Cut evergreen hedges in April and August.
– Cut conifer and other fast growing shrubs ap-
prox. every six weeks from May onwards.
Edging (grass shear only) (see figure D)
Guide the garden product along the edge of the
lawn. Do not allow the blade to contact paved
surfaces, stones or garden walls, since this will
wear the blade rapidly.
For larger lawn it is advisable to use the pole
cart (available as an accessory or supplier with
"grass shear & pole cart" set).
After use replace the blade transport guard.

Maintenance and Service

Maintenance and Cleaning

Warning! Switch off before adjusting or
cleaning. The blades continue to move for a
few seconds after the garden product is
switched off.
Caution! Do not touch the moving blades.
For safe and proper working, always keep
the garden product clean.
Always wear protective gloves when using,
adjusting or cleaning the garden product.
Note: To ensure long and reliable service, carry
out the following maintenance regularly.
Regularly check for obvious defects such as
loose fixings, and worn or damaged compo-
nents.
Check if guards and protective devices are un-
damaged and properly mounted. Before using,
carry out possibly necessary maintenance and
repairs.
If the garden product should happen to fail de-
spite the care taken in manufacture and testing,
repair should be carried out by an authorised
customer service agent for Bosch garden prod-
ucts.
F 016 L70 839 | (6.7.11)
In all correspondence and spare parts orders,
please always include the 10-digit article
number given on the type plate of the garden
product.

Blade Maintenance

Always clean the cutting blades after operation
and lubricate with Bosch Maintenance spray.
During longer cutting jobs, we recommend peri-
odically lubricating the cutting blade with Bosch
Maintenance spray.
Visually check the condition of the cutting edges
of the cutting blade.
Ensure that the cutting blade is covered with the
blade guard supplied when not in use.
Changing the Blade (see figures F1
Warning! Switch off before adjusting or
cleaning. The blades continue to move for a
few seconds after the garden product is
switched off.
Caution! Do not touch the moving blades.
Always wear protective gloves when using,
adjusting or cleaning the garden product.
Do not do the blade change without blade
covers.
Blade Removal (see figures F1–F3)
Push the SDS release button 8 on both
sides.
The SDS drive cover 16 opens.
Pull out the blade 1.
Blade Fitting (see figures F4 – F5)
Push the blade 9 in till it clicks in position.
Push the SDS drive cover 16 towards the
garden product till the SDS release button 8
clicks in position.

After Use/Storage

Warning! Switch off before adjusting or
cleaning. The blades continue to move for a
few seconds after the garden product is
switched off.
Caution! Do not touch the moving blades.
Bosch Power Tools
F5)
–