Battery Charge Indicator; Maintenance And Service - Bosch EasyShear Notice Originale

During the charging procedure, the handle of the machine
warms up. This is normal.
The charger level indicator (1) continuously lights up red
during the charging procedure. When the battery is com-
pletely charged, the charger level indicator (1) goes out.
Disconnect the battery charger from the mains supply when
charging process ends.
Observe the notes for disposal.
Mounting/Removing the Blade (see figures C)
Press the release button (12) and slide the cover (5) toward
the rear. Remove the cover (5) from the housing.
Tilt the blade (6)/(7) upward and then remove the blade
(6)/(7).
Align the recesses on the blade (6)/(7) against the holding
pins and then tilt the blade (6)/(7) downward.
Mount the cover (5) again and then slide it toward the front
until it engages.
Operation
Make sure that the cover of the USB port (2) is shut dur-
u
ing operation. This prevents the penetration of dust.
Do not use a damaged blade (e.g. cracks, etc.). Replace a
u
damaged blade immediately.
Switching On and Off (see figure D)
Press and hold the lock-off button (4) and actuate the On/
Off switch (3).
Release the lock-off button (4).
When actuating the On/Off switch (3), the LED continuously
lights up green.
Troubleshooting
Problem Possible Cause
Cutting time per bat- Battery close to end of service life.
tery charge too low
Charger level indicator Battery temperature too high
lights up red and the
product cannot be
switched on.

Maintenance and Service

Maintenance, Cleaning and Storage
To ensure safe and efficient operation, always keep
u
the power tool and the ventilation slots clean.
For safe and proper working, always keep the product
u
clean.
Do not place other objects on the garden product.
To ensure safe and efficient operation, always keep the
product and the ventilation slots clean.
Bosch Power Tools

Battery Charge Indicator

LED
LED continuously lights up green
LED continuously lights up red
while On/Off switch is halfway
pressed.
Cutting Shrubs (only Shrub Shear)
Make sure that the product is switched off when removing
u
cut-off material or during maintenance. Unintentional
switching on may cause serious injury.
Before cutting check the hedge/shrub for foreign objects
e. g. wire fences.
Cut stems up to 8 mm in thickness. When cutting, move the
product steadily along the line of cut, so that stems are fed
directly into the cutter blades. The double edge of the cut-
ting blade enables cutting to either direction, or with a side
to side motion.
After use, mount the blade guard.
Recommended times
Cut hedges with deciduous leaves in June and October.
Cut evergreen hedges in April and August.
Cut conifer and other fast growing shrubs approx. every six
weeks from May onwards.
Cutting Edges (only Grass Shear)
Guide the product along the edge of the lawn. Prevent the
blade from coming into contact with paved paths, stones or
garden walls because this significantly reduces the lifetime
of the blade.
After use, mount the blade guard.
Corrective Measure
Contact Service Agent.
Ambient temperature too high Do not expose the
product to direct sunlight. Wait 10–15 minutes to
let battery cool down.
Never spray the product with water.
Never immerse the product in water.
Store the product in a secure, dry place, out of the reach of
children.
Do not place other objects on the product.
Keep all nuts, bolts and screws tight to ensure safe working
with the product.
Inspect the product and replace worn or damaged parts for
safety.
Ensure replacement parts fitted are Bosch-approved.
English | 15
Capacity
33−100 %
0−33 %
F 016 L81 893 | (09.12.2019)