Figure 7 : Schéma De Câblage, Moteurs - Chemineer 50DTC Manuel D'installation, D'exploitation Et De Maintenance

Modèle 50DTC, 50DTD
LOW VOLTAGE
T1 T3 T5
L1
CCW ROTATION
NOTE: TO REVERSE MOTOR SHAFT ROTATION,
LOW VOLTAGE
T1 T7 T2 T8
L1 L2
NOTE: TO REVERSE MOTOR SHAFT ROTATION,
CHECK MOTOR LEADS WITH CONNECTION DIAGRAMS ON MOTOR
NAMEPLATE OR CONDUIT BOX FOR PROPER WIRING
CHECK THE MIXER SHAFT ROTATION AGAINST THE PROPER
ROTATION INDICATED ON THE ASSEMBLY DRAWING
NOTE:
THE NORMAL MOTOR SHAFT ROTATION SHOULD BE CCW WHEN
LOOKING AT THE MOTOR FROM THE SHAFT END.
THE NORMAL MIXER SHAFT ROTATION IS CW WHEN LOOKING INTO THE
TANK FOR STANDARD ROTATION IMPELLERS.
INSTALLATION DU MÉLANGEUR
SINGLE-PHASE MOTOR
(WITHOUT THERMAL PROTECTOR)
T2 T4 T8
N
(LOOKING AT THE MOTOR FROM THE SHAFT END)
INTERCHANGE MOTOR LEADS T5 AND T8
THREE-PHASE MOTOR
(WITHOUT THERMAL PROTECTOR)
T3 T9 T4 T5 T6
L3
INTERCHANGE ANY TWO LINE LEADS
Figure 7 : Schéma de câblage, moteurs
17
MONTAGE ET INSTALLATION
HIGH VOLTAGE
T1 T2 T3 T5
L1
HIGH VOLTAGE
T1 T2 T3 T4 T7 T5 T8 T6 T9
L1 L2 L3
T4 T8
L2