Remote Learning - ELAC DS-A101-G Consignes D'utilisation

DS-A101-G App

REMOTE LEARNING

The Remote Learning section allows the DS-
A101-G to learn IR commands from other
remote controls. This can simplify user control
by teaching the amp commands from
another remote such as a TV remote so that
remote can be used to control the TV, DS-
A101-G and other devices if capable.
When learning commands, be sure to use
commands that will make sense when
controlling the amp. Use volume up/down
commands for volume. Use source select
commands for source select functions. Use
transport functions for play/pause/previous/
next.
NOTE: The Play/Pause button is also a mute
button except when used in Bluetooth mode
where it is a pause/play command for a
synchronized Bluetooth device. So...a mute
command will mute/unmute the speakers
for all sources except Bluetooth where it will
pause/play the synchronized device.
1. In the source/Master Volume screen, tap
the Setup Gear in the upper right corner.
From the Setup Menu, tap Remote
Learning. The Remote Learning - Select
screen will appear.
2. In the 'Select' screen tap a button to be
replaced with a new IR command. Follow
the cues on the amp front panel display.
'Scanning' will appear on the display.
3. Press the button on the remote to be
learned until the amp display indicates:
'Captured'. The Display will indicate 'OK'
if the code was learned.
4. When 'Again' appears on the front panel
display, press the SAME BUTTON on the
remote to be learned until the amp
again indicates: 'Captured'.
5. The amp will return to it's previous
operating mode.
6. Press the button on the learned remote
to test the command to be sure the
command has been learned and is
affecting the proper function.
Figure 12 DS-A101-G App -
Remote Learning - Select
Figure 13 DS-A101-G App -
Remote Learning - Learn
18