Bluetooth - ELAC DS-A101-G Consignes D'utilisation

BLUETOOTH

The DS-A101-G has two connections for Bluetooth. One is for Bluetooth Audio Streaming,
(playing music from a phone or tablet via Bluetooth through the DS-A101-G). The other is for
use with the DS-A101-G App.
Minimum Bluetooth Requirements:
Bluetooth Version: v4.0 or better to run the DS-A101-G App
Bluetooth Profiles: A2DP for Bluetooth Audio Streaming and AVRCP for IR control of a paired
phone or tablet
BLUETOOTH PAIRING (BLUETOOTH AUDIO STREAMING)
1. Confirm that Bluetooth is ON on the phone or tablet to be used by going to Settings and
then Bluetooth in the device menu.
2. On the DS-A101-G IR Remote, press the
Next, press and hold the
front panel display.
3. Under Available Devices, look for: ELAC USB Amplifier. This is the connection for Bluetooth
Audio Streaming. Tap it. It should pair to the DS-A101-G.
4. To test, press the
some music on the paired phone or tablet. It should play through the amp. If not, repeat
Steps 1-3 to confirm the ELAC USB Amplifier Bluetooth connection.
Appropriately featured smartphones, tablets and other devices can be paired to the DS-
A101-G Amp via Bluetooth for Bluetooth Audio Streaming. The DS-A101-G IR Remote can
be used to control transport functions, (play/pause, previous/next track) on appropriately
featured phones and tablets for additional control flexibility. See Section: IR Remote Features
for additional information.
BLUETOOTH PAIRING (DS-A101-G App)
The DS-A101-G App is a setup app that can run on either Android or iOS devices. The
Android version can be downloaded from Play Store. The iOS version can be downloaded
from App Store.
1. With the app downloaded and installed, confirm that Bluetooth is ON on the phone or
tablet to be used by going to Settings and then Bluetooth in the device menu.
2. Launch the DS-A101-G App. A black ELAC Screen will appear with an instruction to
select a device from the list. Tap DS-A101-G Control and the app will sync to the amp.
Typically, once the app has been synchronized to the amp from a phone or tablet, unless
the app gets uninstalled, the app will automatically sync to the DS-A101-G amp if the
amp is in range and the app has not been turned off. If the app gets tuned off and gets
relaunched on a previously paired phone or tablet, the app will automatically sync when
launched.
3. To confirm that the app is synchronized to the amp, tap the Analog 1, Analog 2, Coax,
etc. labels at the top of the Master Volume screen. If the source shown on the amp front
panel display changes with the source selected from the app, the app is synchronized.
IMPORTANT NOTE: Bluetooth can be simultaneously connected to two devices, but only
one can play at a given time. If one stops playing, the other can then play. If one device
is connected another can be paired without disconnecting the connected device. If two
devices are connected a new device cannot be paired without disconnecting one of the
connected devices.
button to start the pairing process. 'BT Pair' will appear in the
button on the IR Remote to select the Bluetooth input on the amp. Play
button to switch the amp to the Bluetooth input.
13
Bluetooth