Commissioning And Operation - Klarstein FIGO Mode D'emploi

COMMISSIONING AND OPERATION

• Press the Speed button on the remote control to select a speed: HI: High •
MED: Medium • LOW: Low •
• The switch on the motor housing can be used to influence the direction of
the airflow generated by the rotor blades. Caution: Turn off the fan before
changing the direction of the airflow and wait until the fan has stopped so that
you do not injure yourself or damage the motor.
• Cold Weather: Set the switch to RIGHT to allow the blades to distribute the
warm air under the ceiling to the room below.
• Warm weather: set the switch to LEFT so the blades create a cooling airflow
and distribute it into the room.
• Press the ON/OFF light button on the remote control to turn the light on the
fan on and off.
Remote Control
Use the remote control to change the wind speed and turn the light or fan on/
off. Slide back the battery compartment door and insert two AAA batteries (not
included). Make sure that you insert the batteries the right way round. Then close
the battery compartment again. Make sure that the battery compartment is always
firmly closed. Do not place the remote control in direct sunlight. Do not attempt to
recharge dead batteries. Only charge batteries that are expressly intended for this
purpose. Do not dispose of batteries in fire to prevent explosions.
OFF: Off.
EN
15