Ironing Without Steam; Cleaning & Maintenance - Bosch sensixx B10L Notice D'utilisation

Cork HaNDlE IroN
(model dependent)
To get permanent steam, press the lock button
(15*) and slide it backwards until it locks.
To switch off the permanent steam, slide the lock
button forward.
Important:
• The steam hose may get hot if you are ironing
for long periods.

Ironing without steam

1. Set the required ironing temperature.
2. Begin ironing but without pressing the steam
release button (12).
C
vertical steam
Never direct the steam jet at garments that
are being worn.
Never aim the steam at people or animals.
1. Set the temperature control to the "••" or "max"
position.
2. You can steam iron curtains and hanging
garments (jackets, suits, coats...) by holding
the iron in a vertical position and pressing the
steam release button (12).
Operate the iron vertically at a distance of 10 to
20 cm
Energy saving "eco" setting
(model dependent)
If the "eco" steam setting on the steam regulator
(8*) is selected, the energy consumption of the
appliance will be reduced, by means of the
reduction of water consumption and electricity.
A good ironing result can be obtained for most of
the garments.
Use higher settings only for thick and highly
wrinkled fabrics.
All manuals and user guides at all-guides.com
To extend the life of your steam generator and to
avoid any build up of scale, it is essential that you
rinse out the boiler after several hours of use
(approximately after 50 hours). If the water is
hard, increase the frequency.
Do not use descaling agents for rinsing out the
boiler, as they could damage it.
1. Check that the appliance is unplugged and cold
2. Unscrew the boiler´s cap (1)
3. Empty the boiler above a sink by holding the
4. Fill the boiler with 500 ml of fresh water.
5. Shake the base unit for a few moments and
6. To obtain the best result, we recommend that
7. Close the cap
always unplug the appliance from the mains
supply before carrying out any cleaning or
maintenance operation on it.
1. After ironing, pull out the plug and allow the
2. Wipe the housing, handle and iron body with a
3. If the soleplate is soiled with dirt or scale, clean
4. If the cloth is synthetic, it may melt due to the
5. Never use abrasive products or solvents. To
Cleaning the Boiler
for more than 2 hours.
appliance upside down.
then empty it completely over a sink or bucket.
this operation is done twice
Cleaning &
maintenance
attention! risk of burns!
appliance to cool down before cleaning.
damp cotton cloth.
it with a damp cotton cloth.
high temperature on the soleplate (14). Switch
off the steam and rub off any residue
immediately with a thickly folded, dry cotton
cloth.
keep the soleplate (14) smooth, you should
avoid hard contact with metal objects. Never
use a scouring pad, or chemicals to clean the
soleplate.
15
BOSCH